Our garage doors protect the vehicles, documents and other stuff we store in our garages. It’s a protection that gives security and safety to our belongings. So once it gets damaged, it should be repaired right away. In this article, we are teaching you how to fix a garage door. If you don’t understand the things we prepared in here, you can call professionals of Garage Door Repair in Buford GA who has better understanding of the job.  

Garage Door

As we know, the two components of garage door are the opener and the door itself. We will start with the garage doors. The overhead garage doors operate on the tension of the spring. The springs provide the power that makes the door moves. If the doors don’t work anymore, you can repair it easily.  

Step 1: 

The first thing to do is checking the garage’s metal tracks which can be found inside it. If the mounting brackets are loose, tighten the screws or bolts at the brackets. Work inside the garage while the door is closed. Inspect the tracks for crimps, dents and flat spots. If you find damaged spots, use a rubber mallet to pound them. You can use a block of scrap wood or hammer. It needs replacement if the tracks are badly damaged.  

Step 2:  

Check if the tracks are properly aligned, you can use a level. Vertical tracks should be plumb and the horizontal tracks should slant slightly down. They should be both at the same height on the walls of the garage. If they are not aligned, loosen the bolts or screws. Do not remove them. Tap the tracks into position. Use the level to recheck them again so they are in the right position.  

Step 3: 

It’s now time to clean the tracks to remove the hardened grease and dirt. Use concentrated household cleaner for it. Clean them thoroughly and then wipe dry after.  

Step 5:  

Check for any loose hardware. Check the plates on swing-up doors and tighten the screws if they are loose. On roll-up doors, check the hinges that hold the door’s sections together. If there are damaged hinges, make sure to replace them right away. If a screw hole is enlarged, replace the old screw with a new one but of longer diameter. If there is a cracked wood in the hinge, fill them after removing the hinge.  

Remember, if you have a roll-up door and it has only torsion spring, don’t repair it. The tension could injure you so better call a professional service provider to repair that door. Most of the problems with the garage are related to the opener, so it’s better that a garage door repair specialist will inspect that.  

If you find any signs of a damaged garage door, make sure that you inspect the components right away so you would know where it could have spring from. Do not neglect those obvious signs because it might cause injuries and accidents in the future.